#Stock crack repair cracked#
#Stock crack repair full#
#Stock crack repair professional#

#Stock crack repair cracked#

Second question is has anyone had this issue before? I feel like I take good care of the gun and never expected it to have a dang cracked stock. My main question is should I be worried about using it next weekend? I have a versamax but I am shooting in a sporting clays tourney and would usually use the o/u for that. Only thing I could think is I had it in my truck Friday since I was going straight from work, but I park in a garage and the truck wasn't hot at all when I got there. It has always been safe kept with humidity control, don't expose it to extreme conditions. I will have to figure out that whole process and I doubt it's under warranty. I know I can call Browning or go to a service center (The one listed for Houston is Freer). It is in the grip and goes from the trigger metal back towards the butt of the rifle through the middle of the grip. We repair and restore gun stocks without. have a Browning Cynergy Classic that I have just found a crack in the butt stock. Nicks, chips, dents, cracks and peeling finishes have a devastating effect on the value and appearance of your firearm. Acraglas is a wonderful product and if your stock damage was open/straight enough, you could work it into the crack with thread or dental floss - doesn't look like an option for you. Remove any 'wedge' and clamp immediately with soft jaw clamps. If you can spread the crack as Chuck suggested, again, more's the better. Before you use that method, and since the crack goes clean thru into the barrel channel, when you get your super glue, measure the tapered nozzle, select a drill bit that will allow a tight seal on the nozzle and drill a couple of shallow holes, (deep enought to reach the crack), from inside the channel into the major area of the crack, then, again, from the barrel channel, press the nozzle of the the super glue tightly into the drilled holes and squeeze the bottle, forcing glue to spread into the crack - if a little runs out the outside of the crack, more's the better. If you select a glue with a high flow rate, capillary action alone will draw 'some' glue into the crack. Peter's method provides a good final finish and should be used for final finish. Last edited by PPP MMM 03-01-2008 at 02:59 PM. Gun Refinishing Guide 1 Apply Birchwood Casey Gun Stock Sealer and Filler generously and directly to wood with brush or a clean, lint-free cloth.

#Stock crack repair full#

I've sold that rifle few years ago and the crack never reappeared, even thought that rifle had more than 3500 full loads 500gr/2680-2720fps. 460 Weatherby Mk5 in 1982 when the stock splited after about 60 rounds. I used exactly the above mentioned technique on my very first rifle a.

#Stock crack repair professional#

A professional quality job's done in a mater of few minutes.Īir or an Aceton is not needed. It will finnish the stock like you've never seen before. As it has the same wood filling you won't even recognised it was ever there. Don't be scared to rub/sand with sandpaper. Blow over it with your mouth and repeate several times until the crack is fully filled and finnish. By one or two tube (2ml) of the cheapest Chinese made Super glue with a nozzle, the runnier the better (Cyoanoacrylate) and one or two sheets of 400- 600 grit sandpaper.Ĭut/tear the sandpaper into 35x35mm pieces.Īpply a very tiny amount of the Super glue with the tiny nozzle as deep as possible and immediately sand over the stock crack to create a fine sawdust to stick into the Super glue.